Audacity’s own audiobook recipe is four steps per chapter: a low roll‑off filter, Loudness Normalization to −20 dB RMS, a limiter at −3.5 dB, then the ACX Check plugin. Run noise reduction only if the check still fails the noise floor, and keep it gentle. Export a 192 kbps constant‑bit‑rate MP3 at 44.1 kHz.
Before you start
Export the raw chapter as a 16‑bit WAV and keep it somewhere safe, off the recording computer if you can. Every step below changes the audio for good, and a clean original lets you start again.
Edit first, master last. Cut the stumbles and the lines you read twice, then run the chain on the finished chapter. Select the whole chapter before each effect.
The chain, with settings
| Step | Where in Audacity | Setting |
|---|---|---|
| 1. Roll‑off | Effect › EQ and Filters › Filter Curve EQ | Factory preset “Low roll‑off for speech” |
| 2. Loudness | Effect › Volume and Compression › Loudness Normalization | Normalize RMS to −20 dB |
| 3. Limiter | Effect › Volume and Compression › Limiter | Threshold and make‑up target both −3.5 dB (3.6 and later) |
| 4. Check | Analyze › ACX Check | Peak −3 dB or lower, RMS −23 to −18 dB, noise −60 dB or lower |
Low roll‑off removes rumble below the voice: traffic, footsteps, the desk. You can’t hear most of it, but the ACX Check can.
Loudness Normalization sets the average level. Most home recordings arrive near −27 dB RMS, too quiet for ACX’s −23 to −18 dB.
The limiter catches the loudest moments so no peak goes above −3 dB. It doesn’t change the average level much, which is why the chain needs both. Audacity’s settings are sticky: once set, each step remembers them for the next chapter.
Noise reduction, only if needed
Raising the level raises the room noise with it. If the ACX Check fails the noise floor, use Effect › Noise Removal and Repair › Noise Reduction. Audacity’s guide starts at 6 dB, with sensitivity 6 and frequency smoothing 6, and goes to 9 if that isn’t enough. At 12 it warns the voice can turn “wine‑glassy” and fail ACX’s listening check. The full method is in Audacity noise reduction for audiobooks.
Exporting the MP3
- Project rate 44.1 kHz. A 48 kHz project exports a file ACX rejects.
- MP3, constant bit rate, 192 kbps. Not variable, not 128.
- Mono, for every file in the book.
- One chapter per file, 120 minutes at most.
The format rules are in ACX MP3 format.
Where it goes wrong
- Noise fails after loudness. The file was fine at −27 dB and fails at −20. The room is the problem; see ACX noise floor.
- Too much noise reduction. The numbers pass and the voice sounds metallic. ACX’s listeners reject that too.
- The new limiter. Since Audacity 3.6 the limiter has two thresholds. The old mastering macro sets only one, and users on the Audacity forum reported it pushing chapters to full volume. Set both to −3.5 dB, or use Effect › Legacy › Legacy Limiter. See ACX peaks too high.
- RMS drops after limiting. Usually still inside the window. If it falls below −23, see ACX RMS too low.
- Trimmed silence. ACX wants one to five seconds of real room tone at each end, and the ACX Check needs half a second of it to measure noise. See ACX room tone.
- Chapters that don’t match. Same chain, different rooms or days, different noise. Check every chapter, not only the first.
Audacity 4
Audacity 4.0 came out on 3 September 2026. It supports Nyquist plugins, the format ACX Check uses, but has no Macro Manager, so the Audiobook Mastering macro can’t run. Apply the four steps by hand. We haven’t confirmed that ACX Check runs in 4.0; if it won’t install, see ACX Check plugin not working.
The free ACX Check on this site measures the exported MP3 itself, in your browser, for one chapter or the whole book. It needs no plugin and no Audacity version. ChapterBooth can also run the whole chain for you, with the clicks and repeated lines cut; compare the two in Audacity or ChapterBooth.
Questions
- What RMS should I normalize to in Audacity?
- −20 dB RMS, the value Audacity’s own audiobook guide uses. It sits in the middle of ACX’s −23 to −18 dB window, so the limiter can trim peaks without pushing you out of it.
- Noise reduction before or after normalizing?
- Audacity’s guide sets the level first and reduces noise only if the ACX Check still fails. Measuring after the level goes up shows you the noise ACX will hear.
- Does the Audiobook Mastering macro work in Audacity 4?
- No. Audacity 4.0 shipped without the Macro Manager, so macros can’t run. Apply the four steps by hand, or keep an Audacity 3 install for the macro.
- Why did ACX reject a file that passed in Audacity?
- The plugin measures the audio in the editor, not the MP3 you upload. A 48 kHz project, a variable bit rate or a trimmed room tone fails after export. Check the exported file.
Sources
- Audacity Support, Audiobook mastering, read 12 November 2026.
- Audacity Manual, Noise Reduction and Limiter, read 12 November 2026.
- Audacity Forum, Limiter plugin for ACX files, July and August 2024, read 12 November 2026.
- Audacity 4.0 release date and features: Audacity (audio editor), Wikipedia, read 12 November 2026.
- ACX, audio submission requirements, dated 15 April 2026, read 12 November 2026.