ACX wants the noise floor below −60 dB RMS: the sound of your room between words. Switch off what hums, sit closer to the mic, and use gentle noise reduction. Don’t gate it to dead silence, and don’t raise the level after cleaning.
The number ACX allows
| ACX allows | below −60 dB RMS |
|---|---|
| Measured on | the quietest half second |
| ChapterBooth exports | below −60 dB, every file |
How to measure it
The free ACX Check finds the quietest half second of the file and reports its level in your browser. To test the room before you record, the Room Check listens to ten seconds of quiet and tells you what to change.
Why it happens
- A fridge, fan, heater, air conditioning or laptop running near the mic.
- Chargers and USB interfaces that add a steady whine.
- Recording quietly, then turning the file up: the noise comes up with the voice.
- Traffic, neighbours, rain on a window.
Fix it in Audacity
- Set the level first (Loudness Normalization, RMS, −20 dB) and limit peaks to −3.5 dB. Then clean what is left.
- For hum, use Effect › EQ and Filters › Notch Filter at 60 Hz in the US and Canada, 50 Hz in the UK and Ireland.
- Select two or three seconds where you aren’t speaking. Open Effect › Noise Removal and Repair › Noise Reduction and press Get Noise Profile.
- Select the whole track and open Noise Reduction again. Start at the defaults (6 dB, sensitivity 6), choose Residue and preview: you should hear only noise, never your words. Switch back to Reduce and apply.
- Check again. If you need more than about 12 dB of reduction, the room is the problem.
Fix it in ChapterBooth
Drop the file on the ACX Check and press Fix it free. ChapterBooth removes the noise with a speech‑trained cleaner that leaves your voice alone, then sets the level, so the floor ends below −60 dB. You hear the first minute in about three minutes.
When the noise is too loud to remove without damaging the voice, the check says so before you spend anything, and sends you to the Room Check.
What not to do
- Don’t gate to digital silence. It passes the number and sounds broken. ACX wants real room tone.
- Don’t push noise reduction high. Too much leaves a watery, warbling sound that fails the listening check.
- Don’t normalize after cleaning. Raising the level lifts the floor straight back up.
- Don’t record with the fan on and plan to fix it later. Switching it off takes a second; cleaning it out later is slower and riskier. See recording at home.
Every rule on one page: ACX requirements in plain English. Every rejection reason: why ACX rejects audiobooks.
Questions
Is digital silence between sentences a good idea?
No. Dead silence sounds like the audio dropped out, and ACX asks for real room tone at the start and end of each file. Keep the room’s quiet sound.
Can I use a noise gate?
Only gently, if at all. A gate that slams to silence between words is easy to hear and leaves no room tone.
My noise floor passes but ACX still mentions noise. Why?
A person listens too. A steady whine or hum can be heard under the voice even when the number passes. A notch filter removes hum at one frequency.
Will a better microphone fix it?
Rarely. Most noise is the room: fans, fridges, traffic. Turning those off and sitting closer to the mic does more than new gear.
Sources
- ACX, “What are the ACX audio submission requirements?”, dated 15 April 2026: help.acx.com, read 12 November 2026.