Skip to content

Guide · 4 min read

ACX says your RMS is too high

ACX wants every file to average between −23 and −18 dB RMS. Above −18 dB, the file is too loud, usually from heavy compression or a loudness preset made for podcasts or music. Lower the whole file to about −20 dB RMS and keep the peaks at −3 dB or below.

The number ACX allows

ACX allows−23 to −18 dB RMS
Aim forabout −20 dB RMS
ChapterBooth masters to−19.5 dB RMS

How to measure it

Drop the file on the free ACX Check. It reads the RMS in your browser, without uploading anything, and says how far over you are. A file within 0.3 dB of a limit is marked as only just passing.

Why it happens

  • A compressor or limiter pushed until the waveform looks like a solid block.
  • A podcast or music loudness preset, which aims louder than ACX allows.
  • Normalizing to a perceived‑loudness (LUFS) target instead of RMS.

Fix it in Audacity

  1. Select the whole track (Ctrl+A, or Cmd+A on a Mac).
  2. Open Effect › Volume and Compression › Loudness Normalization. Choose RMS, set −20 dB, and apply. It turns the file down as well as up.
  3. Check the file again. RMS and peaks both drop; the noise floor drops with them.
  4. If the voice sounds flat and squeezed, go back to the original recording and redo the chain with less compression. Turning a squashed file down doesn’t bring the life back.

Fix it in ChapterBooth

Upload your original, unprocessed recording if you still have it, or drop the rejected file on the ACX Check and press Fix it free. ChapterBooth sets every chapter to −19.5 dB RMS with peaks at −3.5 dB, the same for the whole book.

What not to do

  • Don’t stack another compressor to “control” the level. It raises the average again.
  • Don’t turn down only the loud chapters by ear. Set a number for every file, or the book stops matching; see chapters that don’t match.
  • Don’t overshoot. Below −23 dB is a rejection too; see RMS too low.

Every rule on one page: ACX requirements in plain English. Every rejection reason: why ACX rejects audiobooks.

Questions

Is −18 dB RMS exactly a pass?

Yes, −18 dB is inside the range. But −17.9 dB fails, and a small change in a later chapter can tip it over. Aim for about −20 dB.

Isn’t louder better for listeners?

Not on ACX. Above −18 dB RMS the file is rejected, however good it sounds. Listeners set their own volume.

Can compression get a file rejected?

Heavy compression raises the average level and can push it past −18 dB. Use it lightly, or not at all, on spoken word.

Will turning it down make the peaks pass too?

Yes. Lowering the whole file lowers its peaks by the same amount, so a file that passed on peaks still passes.

Sources

  • ACX, “What are the ACX audio submission requirements?”, dated 15 April 2026: help.acx.com, read 12 November 2026.

Published 12 November 2026 · ACX rules checked on help.acx.com on 12 November 2026. ACX and Audible are trademarks of Audible, Inc. ChapterBooth is not affiliated with either.