ACX allows peaks of −3 dB at most. Run a limiter with its ceiling at −3.5 dB to catch them. If the waveform is flat‑topped, the mic clipped while you recorded; no limiter repairs that, so record that passage again.
The number ACX allows
| ACX allows | peaks below −3 dB |
|---|---|
| Set the limiter to | −3.5 dB |
| ChapterBooth limits to | −3.5 dB true peak |
A peak is the loudest single instant in the file: a laugh, a popped “p”, a raised voice.
How to measure it
The free ACX Check measures true peak, the stricter reading, in your browser. It also tells you when the mic clipped and by how much. In Audacity, Analyze › Find Clipping labels every clipped run so you can hear it.
Why it happens
- Plosives: a “p” or “b” that hits the mic. A pop filter helps.
- Laughing, shouting or a sudden loud line.
- Audacity’s Normalize left at its default of −1 dB, which is above ACX’s limit.
- Input gain set so high that the mic clipped.
Fix it in Audacity
- Set the level first, with Loudness Normalization on RMS at −20 dB.
- Open Effect › Volume and Compression › Limiter. Set the threshold and the make‑up target to −3.5 dB, and apply. Older versions have one setting, Limit to: set it to −3.5 dB.
- Check the file again, peaks and RMS together.
Fix it in ChapterBooth
Drop the file on the ACX Check and press Fix it free, or upload it in the studio. ChapterBooth levels the voice, then limits every peak to −3.5 dB true peak before it exports. If the mic clipped, the check says so plainly: move back a hand’s width or turn the input down, then record that part again.
What not to do
- Don’t Normalize to −1 dB. Audacity’s default fails ACX.
- Don’t turn the whole file down to bring one peak under. The average drops with it and can fall below −23 dB; see RMS too low.
- Don’t hide clipping under a limiter. The peak number passes; the crackle doesn’t pass the listening check.
Every rule on one page: ACX requirements in plain English. Every rejection reason: why ACX rejects audiobooks.
Questions
Why set the limiter to −3.5 dB and not −3?
Encoding to MP3 can push peaks up slightly. Half a dB of margin keeps the MP3 you upload below −3 dB.
What is true peak?
The loudest point between samples, which a player can produce when it rebuilds the wave. It reads a little higher than the sample peak, so it is the safer number to check.
Can clipping be repaired?
Not reliably. Audacity’s Clip Fix can soften a few clipped samples, but distortion you can hear stays. Record the passage again.
Will the limiter change my RMS?
A little: it lowers the loudest moments, so the average drops slightly. Check RMS again afterwards.
Sources
- ACX, “What are the ACX audio submission requirements?”, dated 15 April 2026: help.acx.com, read 12 November 2026.