Skip to content

Guide · 5 min read

Audacity noise reduction for audiobooks

Take a noise profile from a few seconds of room tone, then apply Noise Reduction at 6 dB, sensitivity 6, frequency smoothing 6. Go to 9 dB if the noise floor still fails ACX’s −60 dB. If it takes more than that, fix the room instead: heavy reduction makes the voice sound metallic, and ACX rejects that too.

The steps

  1. Record a few seconds of silence at the start of every session: you, still, not speaking.
  2. Select only that room tone. Audacity needs at least 0.05 seconds; more gives a better profile. Choose Effect › Noise Removal and Repair › Noise Reduction, then Get Noise Profile.
  3. Select the whole chapter and open Noise Reduction again.
  4. Set the values below. Press Preview, then switch to Residue to hear what will be removed.
  5. If the residue has no trace of your voice, choose Reduce and press OK.
  6. Run the ACX Check again.

The settings

ControlStart atThen
Noise reduction6 dB9 dB if the check still fails. At 12 the voice can turn metallic
Sensitivity6Lower it if you hear traces of your voice in the Residue preview
Frequency smoothing6 bandsKeep between 1 and 6. Fewer bands if the voice sounds blurred

Audacity’s manual says to use “the lowest value that reduces the noise to an acceptable level”. Its audiobook guide warns that at 12 dB the voice can sound “wine‑glassy or honky” and may fail ACX’s inspection.

When to run it

After the level is set. Loudness Normalization to −20 dB RMS lifts the noise with the voice, so a file that passed at −27 dB can fail at −20. Audacity’s audiobook guide sets the level first, checks, and reduces noise only if the noise floor fails. The full order is in the Audacity ACX workflow.

When it’s the wrong tool

  • Steady hum from a fridge, fan or charger. Switch it off and record again. That’s cheaper than any setting.
  • Echo. Noise Reduction can’t remove it. Record somewhere softer: see the closet vocal booth.
  • Traffic, voices, a dog. These change from second to second, so a profile can’t describe them.
  • Mouth clicks. A different problem, fixed by hand or with a click remover.

The reasons and numbers behind a noise rejection are in ACX noise floor. Run the Room Check before your next session to see the room’s noise in ten seconds, or the ACX Check on a finished chapter.

Questions

What noise reduction settings pass ACX?
Start at 6 dB, sensitivity 6, frequency smoothing 6, as Audacity’s audiobook guide does. Go to 9 dB if the ACX Check still fails. Past that, fix the room.
Why does my voice sound watery after noise reduction?
Too much reduction, or a noise profile taken from the wrong part. Lower the dB, take a new profile from clean room tone, and preview before you apply.
Does Audacity remember my noise profile?
No. The profile is lost when you close Audacity. Take a new one each session, from that session’s room tone.

Sources

Published 12 November 2026